Rapid-air SERVO FEED / RAPID MASTER Manuale Utente Scaricare il pdf (Pagina 11)

11

programming procedure (continued)

Operator Input Terminal – Programming Procedure – Standard Software

The last section to be covered is

the ramp/counters section. To get

into this mode, press the ramp

push-button and the following

screen appears.

SELECT RAMP/COUNTERS

F1=BATCH/TOTAL COUNT

F2=ACCEL/DECEL RAMPS

F4=EXIT TO MAIN MENU

F1 =BATCH/TOTAL COUNTS

Pressing the F1 key will bring up the

batch/total screen, which is used

for presetting the batch count or

resetting the total count. The

following screen appears.

BATCH COUNTER=000000

TOTAL COUNTER=000000

SET:F1=BATCH F2=TOT

F4=RETURN TO RAMP COUNT

Pressing the F1-batch counter key

allows the operator to preset a

batch count.

Pressing the F2-total counter key

resets the total count to zero. This

cannot be undone so be sure that the

counter should be reset to zero before

pressing F2 key.

Pressing the F4 key brings up the

following screen.

SELECT RAMP/COUNTERS

F1=BATCH/TOTAL COUNT

F2=ACCEL/DECEL RAMPS

F4=EXIT TO MAIN MENU

The only section that has not been

covered in this write-up is the ramp

adjust mode. The ramp adjusts how

fast the servo motor gets up to

speed and how fast it stops. This

feature is an asset that is seldom

adjusted but can be a sure cure if

material slippage seems to be

a problem. With the main menu

screen displayed the key labeled

ramp is active. Pressing the ramp

key produces this display.

RAMP PARAMETER MODE

F1=ACCEL% F2=DECEL%

F3=PERCENT MAX SPEED

F4=RETURN RAMP/COUNT

PRESS F1 OR F2

Pressing the F1 or F2 keys will produce

one of the following displays. The

lower the number entered, the longer

the ramp cycle. Press F1 or F2 now.

ENTER IN %ACCEL RATE

MAX%=75000 RPM/SEC

MAX ACCEL%=XXX%

F4=EXIT %ACCEL MENU

ENTER IN %DECEL RATE

MAX%=75000 RPM/SEC

MAX DECEL% = XXX%

F4=EXIT %DECEL MENU

The ramp usually is factory set at .015

on the series 100 drives and .035 on the

series 200 & 300 drives. There is some

deviation to this when the factory runs

the unit, but this is a basic starting point.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Commenti su questo manuale

Nessun commento